International Research Journal of Innovations in Engineering and Technology - IRJIET International Open Access, Monthly, Peer Reviewed, Reputed Journal ISSN (online): 2581-3048

Impact Factor (2025): 6.9

DOI Prefix: 10.47001/IRJIET

Determining the Coordinates of the Points on the Contours of the Development of Quadratic Surfaces and Their Intersections

Abstract

The article presents a method for determining the coordinates of points on the contour of the development of quadratic surfaces and intersections on quadratic surfaces based on the method of analysis, graphic geometry combined with computational programming. The calculation results are programmed in the Autolisp language to determine the coordinates of points on the intersection, thereby constructing the development of quadratic surfaces and their intersections, applied in mechanic and teaching.

Country : Vietnam

1 Nguyen Thi Thu Nga

  1. School of Mechanical Engineering, Hanoi University of Science and Technology, Hanoi, Vietnam

IRJIET, Volume 9, Issue 3, March 2025 pp. 254-260

doi.org/10.47001/IRJIET/2025.903034

Full Paper
Download

References

  1. Phạm Văn Nhuần, Phạm Tuấn Anh “Khai triển các mặt- Ứng dụng máy tính để vẽ hình khai triển” pp. 21–85, 2003.
  2. K Venkata Reddy “Textbook of Engineering Drawing”, BS Publications, Chapter 7, 2008.
  3. N. D. BHatt “Engineering Drawing” Charotar Publishing House, New Delhi, pp. 351–380. 2011.
  4. Nguyen Thi Thu Nga1, Nguyen Thu Huong2, Pham Tuan Anh3, “The method of determining the coordinates of the point on the development of intersections of cylindrical surfaces”, UTEHY Journal of Science and Technology, No. 29, pp. 85–91, March. 2021.
  5. Nguyễn Thị Thu Nga1, Nguyễn Thu Hương2 “Teaching support and detailed mechanical design through the method of machanically determining the development of intersection of cylindrical surfaces”, Tạp chí giáo dục nghề nghiệp, No112, 2023.
  6. Dhananjay Jolhe, “Engineering Drawing with an Introduction to AutoCAD,” Tata McGraw Hill, chapter16, 2017.
  7. M. B Shah, B. C Rana “Engineering Drawing,” Dorling Kindersley Publication (India), pp. 208–230, 2009.

Copyright @ 2026-2017 IRJIET. All Right Reserved.

Developed by Byzero Technologies